I I’m pretty sure that’s a Chihuahua, not a kitty.

I was wondering if it was filmed with a 2000s razr.

No thank you.

I think you might be a bit lost, buddy.

How is that anatomically possible?

People have weird ideas on what blonde is. My SO has straight up auburn hair, but so many people call it strawberry blonde for some reason unbeknownst to us.

She’s not. That’s untreated body dysmorphic disorder.

People like that will never be happy with their looks until they address the root cause instead of finding unethical doctors to butcher them.

I’m not sure this is the right community for this gif.

Lia Lin

If you’re familiar with her work you’d know this isn’t rare at all.

Always go with the Cajun.

If you didn’t, your skin would rip when you stood up

deleted by creator

deleted by creator

I think that’s the standard fine for the first offense. Plus, the violation was not removing something from his website that existed before the gag order, not something he did after.

The judges are following standard procedure so he can’t appeal things when he is sent to jail.

Yup. My wife has a family history of lupus, has kidney issues, had a serious b12 deficiency, and pretty much every other symptom of lupus, but a negative ANA panel, so it can’t be lupus (a negative ANA doesn’t rule it out completely).

When she went in because she was having neuropathic pain, which is very common in lupus and b12 deficiencies, she was told it was probably from her covid vaccine.

What sucks the most is I, a 6’3 male, actually gets taken seriously by the same doctors. It’s bad enough that I have to go with her to appointments so there’s a chance of her being taken seriously.

Yeah, it will affect the print quality because the layers don’t cool off enough in between layers.

I don’t. I dont print enough ABS to worry about fumes.

Although I do have a fan in my office door to suck air out (I also have a 55g aquarium and gaming rig, so it gets to 90F in there without it.

Did you not read my comment about posting an SS member at the door to his cell?

NP. You don’t need a whole lot to get the chamber temps to be ABS friendly. I do recommend keeping it open if printing PLA, though.