• 0 Posts
  • 50 Comments
Joined 1 year ago
cake
Cake day: June 15th, 2023

help-circle








  • Heastes@lemmy.worldtoSelfhosted@lemmy.worldRouters
    link
    fedilink
    English
    arrow-up
    4
    ·
    1 year ago

    I’m using a thinclient (Fujitsu S920), slapped an Intel Pro/1000 NIC in there and installed opnsense. Hardware cost for both used was around €80. Wifi is handled by a TP-Link access point.

    It’s a big boy router/firewall, and it’s been quite a learning experience but very fun.












  • Heastes@lemmy.worldto3DPrinting@lemmy.worldTips for PETG?
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    That’s so strange, I have no problems printing PETG all the time.

    Yeah, I don’t know - I’ve never had any big issues in the past with it either (I mostly print PLA+ though, unless I need something more heat-resistant for my car or outdoor use).

    This particular issue was with an Ender 3 V2 running a BLTouch and an aftermarket textured PEI sheet in an enclosure - so there were no drafts or anything that would explain the bad adhesion either. Just scrubbed it with some water and dish soap. That was literally the only thing I messed with between the spaghetti result run and a great first layer run, so I figured I’d mention it in case it might help OP.