• dolessrem@lemmy.world
    link
    fedilink
    arrow-up
    3
    ·
    1 year ago

    No specific recommendations since now it’s all about taste but sharing my recipe in case there’s something in there you want to try

    1. Brew ratio I’ve liked is 10:1, water to very coarsely ground beans.
    2. Careful with the bloom as the gasses can push your lid. I usually bloom about 75% of the water I’m the container for about an hour than add the rest.
    3. Leave to brew for at least 24 hours at room temperature. Stir the grounds a couple times over the 24 hours.
    4. Filter the large grounds out in a steel filter.
    5. Filter in a paper filter to clean up. I use v60 and it’s pretty fine sludge at this point so I go through a couple filters at this point.
    6. Top off with cold water to reach the 10x grounds volume and chill overnight.
      • dolessrem@lemmy.world
        link
        fedilink
        arrow-up
        2
        ·
        edit-2
        1 year ago

        Assuming you’re using fresh beans, coffee releases c02 when exposed to water. It’s usually the first step in pourover recipes and you can usually see it pretty dramatically.

        Not the best but a quick search found this video with a good enough example: (https://youtu.be/sM3cB0i6ZZU&t=1m50s)

        The bloom for cold brew is just to prevent the gasses popping on your lid if you try to close it too early or overflowing. If you fill the jar with your coffee, then all the way to the top with your water, this blooming phase will spill over water and most likely the crust of all the coffee that hasn’t saturated and sunk to the bottom yet. No good. The hour I have in my recipe is definitely overkill but it’s just an easy (and lazy) easy unit of measurement to call out.