I just want to brag a bit. Printed on an Anycubic Kobra 2. Runs without much problems. At the moment 10 Days on a single winding, tweakble up to 32 days. The weight is from another wooden self build clock.

Edit: cant i upload videos?

Edit 2: https://www.myminifactory.com/object/3d-print-32-day-clock-easy-build-156759 (12$)

Edit 3: I just printed this clock, i didnt plan it myself if this is unclear…

  • I_Miss_Daniel@kbin.social
    3·
    9 months ago

    Nearly finished the same one. Was too cold though and my ender 3 kept warping the bob off the bed. Now it’s warmed up again I should finish it.

    If it’s the same as mine, you had to buy a few ball bearings and steal the springs out of three pens to make it. Also had to use a chopped up fishing jag and a garden trellis for the rods.