I understand the intent, but feel that there are so many other loopholes that put much worse weapons on the street than a printer. Besides, my prints can barely sustain normal use, much less a bullet being fired from them. I would think that this is more of a risk to the person holding the gun than who it’s pointing at.

  • nyan@lemmy.cafe
    link
    fedilink
    English
    arrow-up
    18
    ·
    1 year ago

    Well, not anything (if you actually think that’s possible, then I have a challenge for you: make a functioning gun out of cheese), but an average hardware store should have everything you need to produce something capable of firing a shot.

    • Cethin@lemmy.zip
      link
      fedilink
      English
      arrow-up
      10
      arrow-down
      1
      ·
      1 year ago

      Usually part of 3D printed guns aren’t 3d printed. I’d bet you could make a one-time-use gun out of cheese, but the firing pin and springs would probably have to be made of something else to use a traditional round.

      If you go with a gunpowder charge ignited with a flame, it’d be much easier. I’m sure there’s even a cheese that could sustain a flame to ignite it with too. You could even make a cheese bullet.

    • bitsplease@lemmy.ml
      link
      fedilink
      English
      arrow-up
      8
      ·
      1 year ago

      if you actually think that’s possible, then I have a challenge for you: make a functioning gun out of cheese

      Sounds like something Mythbusters would’ve taken on back in the day lol

    • funkless_eck@sh.itjust.works
      link
      fedilink
      English
      arrow-up
      5
      ·
      1 year ago

      I reckon you could do it with Himalayan Chhurpi (yak) cheese.

      Some people find it so hard they literally can’t eat it.

    • Owl@mander.xyz
      link
      fedilink
      English
      arrow-up
      5
      arrow-down
      1
      ·
      1 year ago

      Even if you freeze the cheese to make it more solid ?